VW MicroBus Split 1960
click on image to get a full view



Tools

My welder. Used mostly flux wire and recently added a gaz bottle and welding is muuch easier. Its a Mastercraft from Canadian Tire, bought used and well used.


My compressor. Its an old DevilBiss, 35 Gallon 2 hp.



Fall 2000

This is the ad that was on Hebdo.net


Rented a Tow-Dolly from U-haul, towed with my Westfalia 1973 from st-ephrem de beauce (QC).



Winter 2001

Nose work to be done....


Rims been blasted and painted, new tire, removed rusty rockers, Doglegs fell apart!.



Summer 2001

Front section, removed rusty front floor part


Cleaned and POR15 treated on the Frame.
Gas tank restored by a professionnal shop



Winter-Spring 2002

Cargo floor replaced


Outrigger before and After!!


Side view, frame with POR15, pillar, outrigger and rocker all new and welded


View from the engine bay, the passenger side corner still has to be done!



Summer 2002

Nose work and test fit of MetalWizard part(www.metwiz.com)


Axle Beam swap from the 60 to a 66. Better brake, cheaper brake cylinder and link pin!



Winter 2003

Test fit for a used 1960 dogleg. Its not in perfect shape but fit way better than aftermarket one



Summer-fall 2003

Spring 2003, New house and new garage built by me and my brother in law

My new garage and the nose skin ready to be done


Front


Interior installed


New corner welded and engine installed


New rocker and pillar


Restored front brake componement! Backplate powdercoated


New Master Cylinder and link pin


October 2003: Stuck Drum. Tried professionnal pullers, havent move from an inch!


December 2003: Have cut it to remove the brake componement, tried to cut all the drum...


...but finally, i ended removing the Reduction Box cover ...using a hammer the cover AND the drum still attached falled on the ground.Then,using a 3 ton press, i was able to get rid of the old drum. While im there i'll change all the bearing and gasket of the Reduction Box.

January 2004: Finally the big nose job is starting...

March 2004: Welded the bullet, then sent the nose to a body shop to repair lower section



August 2004

Safari installation



Gas Pedal Repair



Nose Repair continued



August statement



Main page


Thanks to all people helping me for part:

Todd and Cory, the Cornwall folks, for your help and part and friendhsip
My girlfriend for his patience about all my toys
All the internet community for incredible knowledge